Consists of verticals and captive collars welded on them at 1000/500 mm. centres. Transoms. ledgers and diagonals having spigot ends get locked firmly to the verticals by free locking collars
• Ideal as access scaffolding along straight or curved face
Locate the blade end of Horizontal into lower
Lower the upper cup Down
Tighten with a hammer blow
A positive & rigid connection of four units is achieved in one single action
Vertical / Standard Cuplock
Vertical are available to suit any propping or access application economically. The connection point is set at 500/1000mm vertical intervals for maximum variation in use. The lower cups are welded in position, the upper moveable cups are retained by a fixed stop. The vertical are drilled for the fixing of SPIGOT joint. A bolt can be used to restrain upward forces if required. These are available in different sizes of 3000mm, 2500mm, 2000mm, 1500mm, 1000mm or as required
Horizontals / Ledgers
Horizontals are available in a range or standard sizes of can be made to a special length if required. The forged blade end fits in the cup of the Vertical The simple robust design ensure that horizontals need no maintenance. These are available in the following sizes:
2500mm, 2000mm, 1500mm, 1250mm, 1000mm, 500mm or i.e. effective length.
effective length = centre of the two vertical
Horizontals / Ledgers
When necessary verticals are connected end to end by an internal Spigot (Square/Round). This is bolted to the lower Vertical
